1-6
Executing the reset garp statistics command without any parameter clears the GARP statistics of all
ports.
Related commands: display garp statistics.
Examples
# Clear GARP statistics of all ports.
<Sysname> reset garp statistics
GVRP Configuration Commands
display gvrp statistics
Syntax
display gvrp statistics [ interface interface-list ]
View
Any view
Parameters
interface interface-list: Specifies an Ethernet port list. By providing a value for this argument, you can
display the GVRP statistics on the specified ports. You need to provide the interface-list argument in the
format of { interface-type interface-number [ to interface-type interface-number ] } &<1-10>, where the
interface-type argument represents the port type, the interface-number argument represents the port
number, and & <1-10> means that you can provide up to 10 port indexes/port index ranges for this
argument.
Note that, this command displays GVRP statistics only on the trunk ports included in the list. Statistics
on non-trunk ports will not be displayed.
Description
Use the display gvrp statistics command to display the GVRP statistics of trunk ports.
This command displays the following information:
z GVRP status
z Number of the GVRP entries that fail to be registered
z Source MAC address of the previous GVRP PDU
z GVRP registration type of a port
Examples
# Display the GVRP statistics of Ethernet1/0/1, assuming that the port is a trunk port.
<Sysname> display gvrp statistics interface Ethernet 1/0/1
GVRP statistics on port Ethernet1/0/1
GVRP Status : Enabled
GVRP Failed Registrations : 0
GVRP Last Pdu Origin : 0000-0000-0000
GVRP Registration Type : Normal
To Next Page
Loading...
Need help?
General