1-8
Use the undo web-authentication timer idle-cut command to restore the default.
By default, the idle user checking interval is 900 seconds for Web authentication.
The idle user checking interval is the interval at which the system checks whether a user is idle. When a
user is found idle, if the corresponding MAC address entry has not been aged out, the system keeps the
user online; otherwise, the system logs off the user. You are recommended to set the interval to a value
that is greater than half of the MAC address entry aging time but less than the MAC address entry aging
time.
Examples
# Set the idle user checking interval to 500 seconds for Web authentication.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] web-authentication timer idle-cut 500
web-authentication web-server
Syntax
web-authentication web-server ip ip-address [ port port-number ]
undo web-authentication web-server
View
System view
Parameters
ip-address: IP address of the Web authentication server. It must be a valid unicast address.
port-number: Port number of the Web authentication server. It ranges from 1 to 50000, with 80 as the
default.
Description
Use the web-authentication web-server ip command to set the IP address and port number of the
Web authentication server, which will be used for Web authentication of users.
Use the undo web-authentication web-server command to restore the default.
By default, no Web authentication server IP address is set and the port number is 80.
To Next Page
Loading...
Need help?
General