1-11
Table 1-6 mtracert command output description
Field Description
From last-hop router(192.168.2.2),
trace reverse path to source
192.168.4.1 via RPF rules
Reverse path from the last-hop router (192.168.2.2) to the
multicast source (192.168.4.1)
-1 5.5.5.8
Outgoing interface address of each hop, starting from the
last-hop router
Incoming interface address Address of the interface on which (S, G) packets arrive
Previous-hop router address
IP address of the router from which this local device
receives multicast packets sent by the source
Input packet count on incoming
interface
Total number of multicast packets received on the incoming
interface
Output packet count on outgoing
interface
Total number of multicast packets transmitted on the
outgoing interface
Total number of packets for this
source-group pair
Total number of packets from the specified source
forwarded by this device to the specified group
Protocol The multicast routing protocol in use
Forwarding TTL
The minimum TTL that a packet is required to have before it
can be forwarded over the outgoing interface
multicast route-limit
Syntax
multicast route-limit limit
undo multicast route-limit
View
System view
Parameters
limit: Maximum number of multicast routing table entries, in the range of 0 to 256.
Description
Use the multicast route-limit command to configure the maximum number of entries the multicast
routing table can hold. The switch will drop the protocol and data packets for new (S, G) entries after the
limit is reached.
Use the undo multicast route-limit command to restore the default.
The maximum number of entries the multicast routing table can hold is 256 by default.
If the number of existing entries in the multicast routing table exceeds the value configured with this
command, the existing entries in the multicast routing table will not be immediately removed. Instead,
you will see a message indicating that the multicast routing table currently contains more entries than
configured.
If you execute this command again, the new configuration will overwrite the existing configuration.
To Next Page
Loading...
Need help?
General