1-20
system, file transfer protocol (FTP), trivial file transfer protocol (TFTP), downloading using
XModem, user management, and level setting are at administration level.
Refer to CLI for detailed introduction to the command level.
Examples
# Configure commands at level 0 are available to the users logging in using the user name of zbr.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] local-user zbr
[Sysname-luser-zbr] service-type telnet level 0
# To verify the above configuration, you can quit the system, log in again using the user name of zbr,
and then list the available commands, as listed in the following.
<Sysname> ?
User view commands:
cluster Run cluster command
display Display current system information
nslookup Query Internet name servers
ping Ping function
quit Exit from current command view
super Set the current user priority level
telnet Establish one TELNET connection
tracert Trace route function
undo Cancel current setting
set authentication password
Syntax
set authentication password { cipher | simple } password
undo set authentication password
View
User interface view
Parameters
cipher: Specifies to save the local password in cipher text.
simple: Specifies to save the local password in plain text.
password: Password to be set. The password must be in plain text if you specify the simple keyword in
the set authentication password command. If you specify the cipher keyword, the password can be
in either cipher text or plain text, as described in the following.
z When you enter the password in plain text containing no more than 16 characters (such as 123),
the system converts the password to the corresponding 24-character encrypted password.
z When you enter the password in cipher text containing 24 characters, make sure you are aware of
the corresponding password in plaintext. For example, the plain text “123456” corresponds to the
cipher text “OUM!K%F<+$[Q=^Q`MAF4<1!!”.
To Next Page
Loading...
Need help?
General