1-60
Examples
# Use hello as the shared key for HWTACACS accounting messages in HWTACACS scheme hwt1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] key accounting hello
nas-ip
Syntax
nas-ip ip-address
undo nas-ip
View
HWTACACS scheme view
Parameters
ip-address: Source IP address to be set, an IP address of this device. This address can neither be the
all 0's address nor be a Class D address.
Description
Use the nas-ip command to set the source address of outgoing HWTACACS messages.
Use the undo nas-ip command to restore the default setting.
Note that:
z You can set the source address of HWTACACS messages to avoid messages returned from
server from being unable to reach their destination due to physical interface trouble. It is
recommended to use a Loopback interface address as the source IP address.
z You can set only one source IP address by using this command. When you re-execute this
command again, the newly set source IP address will overwrite the old one.
Related commands: display hwtacacs.
Examples
# Set source IP address 10.1.1.1 for outgoing HWTACACS messages in HWTACACS scheme hwt1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] nas-ip 10.1.1.1
primary accounting
Syntax
primary accounting ip-address [ port ]
undo primary accounting
To Next Page
Loading...
Need help?
General