3-4
Description
Use the display rip interface command to display RIP interface information.
Examples
# Display RIP interface information.
<Sysname> display rip interface
RIP Interface: public net
Address Interface Ver MetrIn/Out Input Output Split-horizon
1.0.0.1 Vlan-interface100 2 0/1 on on on
Table 3-2 Description on the fields of the display rip interface command
Field Description
Address
IP address of the interface running RIP (You need to use the network
command to enable the network segment on which the address resides.)
Interface
Name of the interface running RIP. The IP address of the interface
corresponds to that in the Address field.
Ver Version of RIP running on the interface
MetrIn/Out Additional metric added when a route is received/sent
Input
Indicates whether to allow the interface to receive RIP packets (on means
yes; off means no).
Output
Indicates whether to allow the interface to send RIP packets (on means
yes; off means no).
Split-horizon Indicates whether split horizon is enabled (on means yes; off means no)
display rip routing
Syntax
display rip routing
View
Any view
Parameters
None
Description
Use the display rip routing command to display RIP routing information.
Examples
# Display the information of the RIP routing table.
<Sysname> display rip routing
RIP routing table: public net
To Next Page
Loading...
Need help?
General