1-4
From the above example, you can see the original unit ID of the device with MAC address
000f-cbb7-3264 is 6. After the configuration, this unit ID changes to 4, and the priority of the device
changes to 5.
display ftm
Syntax
display ftm { information | topology-database }
View
Any view
Parameters
information: Displays the FTM module information, including DDP status, unit ID, link status of the
fabric, status of the fabric port, and DDP packet statistics.
topology-database: Displays the topology database information of the fabric.
Description
Use the display ftm command to display the protocol information or the topology database information
of the current fabric.
Examples
# Display the FTM module information of the switch.
<Sysname> display ftm information
FTM State : HB STATE
Unit ID : 2 (FTM-Master)
Fabric Type : Line
Fabric Auth : NONE
Fabric Vlan ID : 4093
Left Port : Disable
Right Port : Normal
Advertise : Send = 5, Receive = 3
Advertise ACK : Send = 0, Receive = 5
Heart Beat : Send = 20, Receive = 0
Left Port : Index = 255, IsEdge = 0
Right Port : Index = 25, IsEdge = 0
Units Num Left : 1
Units Num Right : 2
Units Num Backup: 2
To Next Page
Loading...
Need help?
General