1-1
1 UDP Helper Configuration Commands
UDP Helper Configuration Commands
display udp-helper server
Syntax
display udp-helper server [ interface Vlan-interface vlan-id ]
View
Any view
Parameters
vlan-id: VLAN interface number.
Description
Use the display udp-helper server command to display the UDP broadcast relay forwarding
information. The information includes the VLAN interface enabled with UDP Helper, IP address of the
destination server, and the number of UDP packets forwarded to the destination server. If a vlan-id is
specified, UDP broadcast relay forwarding information of the specified VLAN interface is displayed.
Examples
# Display the UDP broadcast relay forwarding information on VLAN-interface 1.
<Sysname> display udp-helper server interface Vlan-interface 1
Interface name Server address Packets sent
Vlan-interface1 192.1.1.2 0
The information above shows that the IP address of the destination server corresponding to
VLAN-interface 1 is 192.1.1.2, and no packets have been forwarded to the destination server.
Table 1-1 Description on the fields of the display udp-helper server command
Field Description
Interface name Interface enabled with UDP Helper
Server address Destination server IP address to which UDP packets are forwarded
Packets sent Number of UDP packets forwarded to the destination server
reset udp-helper packet
Syntax
reset udp-helper packet
To Next Page
Loading...
Need help?
General