1-5
Because Smart Link and STP cannot be enabled on an Ethernet port at the same time, you must make
sure that STP is disabled on the port before assigning the port to a smart link group.
Examples
# Configure Ethernet 1/0/6 as the slave port of smart link group 1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] smart-link group 1
[Sysname-smlk-group1] port Ethernet 1/0/6 slave
port smart-link group
Syntax
port smart-link group group-id { master | slave }
undo port smart-link group group-id
View
Ethernet port view
Parameters
group-id: Smart link group ID, in the range of 1 to 24.
master: Specifies the port as the master port of the smart link group.
slave: Specifies the port as the slave port of the smart link group.
Description
Use the port smart-link group command to assign the current port to a smart link group.
Use the undo port smart-link group command to remove the current port from the specified smart link
group.
The port where you configure the command cannot be a link aggregation group member port.
Besides assigning single ports to a smart link group, you can assign a link aggregation group (static or
manual, but not dynamic) to a smart link group with the link-aggregation group command in smart link
group view.
Because Smart Link and STP cannot be enabled on an Ethernet port at the same time, you must make
sure that STP is disabled on the port before assigning the port to a smart link group.
To Next Page
Loading...
Need help?
General