1-24
Trying 129.102.0.1 ...
Press CTRL+K to abort
Connected to 129.102.0.1 ...
**************************************************************************
* Copyright(c) 2004-2008 Hangzhou H3C Tech. Co., Ltd. All rights reserved. *
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
**************************************************************************
<SwitchB>
telnet ipv6
Syntax
telnet ipv6 remote-system [ -i interface-type interface-number ] [ port-number ]
View
User view
Parameters
remote-system: IPv6 address or host name of the remote system. An IPv6 address can be up to 46
characters; a host name is a string of 1 to 20 characters.
-i interface-type interface-number: Specifies the outbound interface by interface type and interface
number. The outbound interface is required when the destination address is a local link address.
port-number: TCP port number assigned to Telnet service on the remote system, in the range 0 to
65535 and defaults to 23.
Description
Use the telnet ipv6 command to Telnet to a device from the current device to perform remote
management operation. You can terminate a Telnet session by pressing Ctrl+K.
Example
# Telnet to the device with IPv6 address 3001::1.
<Sysname> telnet ipv6 3001::1
Trying 3001::1 ...
Press CTRL+K to abort
Connected to 3001::1 ...
**************************************************************************
* Copyright (c) 2004-2008 Hangzhou H3C Tech. Co., Ltd. All rights reserved.*
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
**************************************************************************
<Sysname>
To Next Page
Loading...
Need help?
General