1-26
Note that when the telnet source-ip command is executed, if the IP address specified is not an IP
address of the local device, your configuration fails.
Examples
# Set the source IP address to 192.168.1.1 for the Telnet client.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] telnet source-ip 192.168.1.1
telnet-server source-interface
Syntax
telnet-server source-interface interface-type interface-number
undo telnet-server source-interface
View
System view
Parameters
interface-type interface-number: Interface type and interface number.
Description
Use the telnet-server source-interface command to specify the source interface for a Telnet server.
Use the undo telnet-server source-interface command to remove the source interface.
The source interface can be a loopback interface or a VLAN interface. If the specified interface does not
exist, the system prompts that this configuration fails, and the login succeeds only when there is a route
between the Telnet client and the specified source interface.
With the telnet-server source-interface command configured, the client can log in to the local device
using only the primary IP address of the specified interface.
Examples
# Specify VLAN-interface 2 as the source interface for the Telnet server.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] telnet source-interface Vlan-interface 2
telnet-server source-ip
Syntax
telnet-server source-ip ip-address
undo telnet-server source-ip
View
System view
To Next Page
Loading...
Need help?
General