1-9
Parameters
protocol: You can provide one of the following values for this argument.
z direct: Displays direct-connect route information
z ospf: Displays OSPF route information.
z ospf-ase: Displays OSPF ASE route information.
z ospf-nssa: Displays OSPF not-so-stubby area (NSSA) route information.
z rip: Displays RIP route information.
z static: Displays static route information.
inactive: With this argument provided, this command displays the inactive route information. Without
this argument provided, this command displays both active and inactive route information.
verbose: With this keyword specified, detailed information of routes in the active or inactive state is
displayed. With this keyword not specified, brief information of only the routes in the active state is
displayed.
Description
Use the display ip routing-table protocol command to display the route information of a specific
protocol.
Examples
# Display the summary of all direct-connect routes.
<Sysname> display ip routing-table protocol direct
DIRECT Routing tables:
Summary count: 4
DIRECT Routing tables status:<active>:
Summary count: 3
Destination/Mask Protocol Pre Cost Nexthop Interface
20.1.1.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
127.0.0.0/8 DIRECT 0 0 127.0.0.1 InLoopBack0
127.0.0.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
DIRECT Routing tables status:<inactive>:
Summary count: 1
Destination/Mask Protocol Pre Cost Nexthop Interface
210.0.0.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
For detailed description of the output information, see Table 1-1.
display ip routing-table radix
Syntax
display ip routing-table radix
View
Any view
Parameters
None
To Next Page
Loading...
Need help?
General