1-25
# Display information about SSH users.
[Sysname] display ssh user-information
Username Authentication-type User-public-key-name Service-type
user1 publickey null stelnet
ssh client assign
Syntax
ssh client { server-ip | server-name } assign { publickey | rsa-key } keyname
undo ssh client { server-ip | server-name } assign { publickey | rsa-key }
View
System view
Parameters
server-ip: IP address of the server.
server-name: Name of the server, a string of 1 to 184 characters.
keyname: Name of the public key of the server, a string of 1 to 64 characters.
Both publickey and rsa-key indicate specifying the publickey key. They are implemented with the same
method.
Description
Use the ssh client assign command to specify the name of the public key of the server on the client so
that the client can authenticate whether the server to be accessed is reliable.
Use the undo ssh client assign command to remove the mapping between the client and the public
key of the server.
By default, a client does not have the name of the server’s public key specified and it uses the IP
address or host name that it used to log in to the SSH server as the public key name.
If a client does not support first-time authentication, it will refuse to access any unauthenticated server.
In this case, you need to configure the public key of the server on the client and associate the public key
and the server so that the client can authenticate the server during login.
To Next Page
Loading...
Need help?
General