1-4
View
Local user view
Parameters
ip ip-address: Sets the IP address of the user.
mac mac-address: Sets the MAC address of the user. Here, mac-address is in H-H-H format.
idle-cut second: Enables the idle-cut function for the local user and sets the allowed idle time. Here,
second is the allowed idle time, which ranges from 60 to 7,200 seconds.
access-limit max-user-number: Sets the maximum number of users who can access the switch with
the current username. Here, max-user-number ranges from 1 to 1,024.
vlan vlan-id: Sets the VLAN attribute of the user (that is, specifies to which VLAN the user belongs).
Here, vlan-id is an integer ranging from 1 to 4094.
location: Sets the port binding attribute of the user.
nas-ip ip-address: Sets the IP address of an access server, so that the user can be bound to a port on
the server. Here, ip-address is in dotted decimal notation and is 127.0.0.1 by default (representing this
device). When binding the user to a remote port, you must use nas-ip ip-address to specify a remote
access server IP address. When binding the user to a local port, you need not use nas-ip ip-address.
port port-number: Sets the port to which you want to bind the user. Here, port-number is in the format of
device ID/slot number/port number; the device ID ranges from 1 to 8, the slot number ranges from 0 to
15 (if the bound port has no slot number, just input 0 for this item) and the port number ranges from 1 to
255.
Description
Use the attribute command to set the attributes of a user whose service type is lan-access.
Use the undo attribute command to cancel attribute settings of the user.
You may use display local-user command to view the settings of the attributes.
Examples
# Create local user user1 and set the IP address attribute of user1 to 10.110.50.1, allowing only the user
using the IP address of 10.110.50.1 to use the account user1 for authentication.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] local-user user1
New local user added.
[Sysname-luser- user1] password simple pass1
[Sysname-luser- user1] service-type lan-access
[Sysname-luser-user1] attribute ip 10.110.50.1
authentication
Syntax
authentication { radius-scheme radius-scheme-name [ local ] | hwtacacs-scheme
hwtacacs-scheme-name [ local ] | local | none }
undo authentication
To Next Page
Loading...
Need help?
General