3-3
RIP is running
Checkzero is on Default cost : 1
Summary is on Preference : 100
Traffic-share-across-interface is off
Period update timer : 30
Timeout timer : 180
Garbage-collection timer : 120
No peer router
Network :
202.38.168.0
Table 3-1 Description on the fields of the display rip command
Field Description
RIP is running RIP is active.
Checkzero
State of the must be zero field check for RIP-1 packets
on: Enabled
off: Disabled
Default cost Default cost for redistributed routes
Summary
State of the automatic route summarization function:
on: Enabled
off: Disabled
Preference RIP preference
Period update timer Length of the period update timer in seconds
Timeout timer Length of the timeout timer in seconds
Garbage-collection timer Length of the garbage-collection timer in seconds
No peer router No destination address of a transmission is specified
Network Network segment on which RIP is enabled
Traffic-share-across-interface
State of load sharing among interfaces:
on: Enabled
off: Disabled
display rip interface
Syntax
display rip interface
View
Any view
Parameters
None
To Next Page
Loading...
Need help?
General