1-1
1 Basic System Configuration and Debugging
Commands
z The configuration of real-time monitoring of the running status of the system is added. For the
detailed configuration, refer to section
system-monitor enable.
z The configuration of loading hot patch is added. For the detailed configuration, refer to sections
display patch-information, patch activate, patch delete, patch load, and patch run.
z The configuration of identifying and diagnosing pluggable transceivers is added. For the detailed
configuration, refer to sections
display transceiver alarm interface, display transceiver diagnosis
interface
, display transceiver interface, and display transceiver manuinfo interface.
z The language-mode command is deleted.
Basic System Configuration Commands
clock datetime
Syntax
clock datetime HH:MM:SS { YYYY/MM/DD | MM/DD/YYYY }
View
User view
Parameters
HH:MM:SS: Current time, namely, hour:minute:second. HH ranges from 0 to 23, and MM and SS range
from 0 to 59.
YYYY/MM/DD or MM/DD/YYYY: Current date, where YYYY represents year ranging from 2000 to 2099,
MM represents month ranging from 1 to 12, and DD represents day ranging from 1 to 31.
Description
Use the clock datetime command to set the current date and time of the Ethernet switch.
By default, it is 23:55:00 04/01/2000 when the system starts up.
In an implementation where exact absolute time is required, it is necessary to use this command to set
the current date and time of the Ethernet switch.
After the setting, you can use the display clock command to check your configuration.
To Next Page
Loading...
Need help?
General