1-1
1 MAC Address Table Management Configuration
Commands
z This chapter describes the management of static, dynamic, and blackhole MAC address entries.
For information about the management of multicast MAC address entries, refer to the “Multicast
Protocol” part of the manual.
z The function of destination MAC address triggered update was introduced. For detailed description,
refer to the description of the command
mac-address aging destination-hit enable.
z The function of assigning MAC addresses for Ethernet ports was introduced. For detailed
description, refer to the description of the commands
display port-mac and port-mac.
MAC Address Table Management Configuration Commands
display mac-address aging-time
Syntax
display mac-address aging-time
View
Any view
Parameters
None
Description
Use the display mac-address aging-time command to display the aging time of the dynamic MAC
address entries in the MAC address table.
Related commands: mac-address, mac-address timer, display mac-address.
Examples
# Display the aging time of the dynamic MAC address entries.
<Sysname> display mac-address aging-time
Mac address aging time: 300s
The output information indicates that the aging time of the dynamic MAC address entries is 300
seconds.
To Next Page
Loading...
Need help?
General