1-24
loopback-detection interval-time
Syntax
loopback-detection interval-time time
undo loopback-detection interval-time
View
System view
Parameters
time: Time interval for loopback detection, in the range of 5 to 300 (in seconds). It is 30 seconds by
default.
Description
Use the loopback-detection interval-time command to set time interval for loopback detection.
Use the undo loopback-detection interval-time command to restore the default time interval.
Examples
# Set time interval for loopback detection to 10 seconds.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] loopback-detection interval-time 10
loopback-detection per-vlan enable
Syntax
loopback-detection per-vlan enable
undo loopback-detection per-vlan enable
View
Ethernet port view
Parameters
None
Description
Use the loopback-detection per-vlan enable command to configure the system to run loopback
detection on all VLANs of the current trunk or hybrid port.
Use the undo loopback-detection per-vlan enable command to restore the default setting.
By default, the system runs loopback detection only on the default VLAN of the trunk or hybrid port.
Note that the command is invalid for any access port.
Examples
# Configure the system to run loopback detection on all VLANs of the trunk port Ethernet 1/0/1.
<Sysname> system-view
To Next Page
Loading...
Need help?
General