1-12
Parameters
vlan-id-list: List of the VLANs that the current hybrid port will be assigned to or removed from. In this list,
you can specify individual VLAN IDs (each in the form of vlan-id) and VLAN ID ranges (each in the form
of vlan-id1 to vlan-id2). Specify each VLAN ID in the range of 1 to 4094 and ensure that vlan-id2 is no
less than vlan-id1. The total number of individual VLAN IDs and VLAN ID ranges defined in the list must
not exceed 10. Be sure that the specified VLANs already exist.
tagged: Keeps VLAN tags when the packets of the specified VLANs are forwarded on the port.
untagged: Removes VLAN tags when the packets of the specified VLANs are forwarded on the port.
Description
Use the port hybrid vlan command to assign the hybrid port to one or multiple VLANs and configure
the port to send packets tagged or untagged for the VLAN(s).
Use the undo port hybrid vlan command to remove the hybrid port from the specified VLAN(s).
By default, a hybrid port only allows packets from VLAN 1 to pass through untagged.
You can configure the port hybrid vlan vlan-id-list { tagged | untagged } command multiple times. The
VLANs specified each time does not overwrite those configured before, if any.
The VLAN specified by the vlan-id argument must already exist. Otherwise, this command is invalid.
Related commands: port link-type.
Examples
# Assign hybrid port Ethernet 1/0/1 to VLAN 2, VLAN 4, and VLAN 50 through VLAN 100; configure the
port to keep VLAN tags when sending the packets of these VLANs.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] port link-type hybrid
[Sysname-Ethernet1/0/1] port hybrid vlan 2 4 50 to 100 tagged
port link-type
Syntax
port link-type { access | hybrid | trunk | irf-fabric }
undo port link-type
View
Ethernet port view
Parameters
access: Sets the link type of the current port to access.
hybrid: Sets the link type of the current port to hybrid.
trunk: Sets the link type of the current port to trunk.
irf-fabric: This argument is used for configuring a fabric port and is beyond the scope of VLAN
Command. For how to use the keyword, refer to IRF Fabric Command of this manual.
To Next Page
Loading...
Need help?
General