1-4
Ethernet1/0/3 0 Ethernet1/0/4 0
Ethernet1/0/5 0 Ethernet1/0/6 0
Ethernet1/0/7 0 Ethernet1/0/8 0
Ethernet1/0/9 0 Ethernet1/0/10 12400
……
<Omitted>
display poe powersupply
Syntax
display poe powersupply
View
Any view
Parameters
None
Description
Use the display poe powersupply command to view the parameters of the power sourcing equipment
(PSE).
Examples
# Display the PSE parameters.
<Sysname> display poe powersupply
Unit 1
PSE ID :0
PSE Legacy Detection :disable
PSE Total Power Consumption :0 mW
PSE Available Power :300000 mW
PSE Peak Value :0 mW
PSE Average Value :0 mW
PSE Software Version :290
PSE Hardware Version :000
PSE CPLD Version :078
PSE Power-Management mode :auto
Table 1-3 display poe powersupply command output description
Field Description
PSE ID Identification of the PSE
PSE Legacy Detection
The enabled/disabled status of the nonstandard
PD detection
PSE Total Power Consumption Total power consumption of the PSE
PSE Available Power Available power of the PSE
Power Peak Value Peak power value of the PSE
To Next Page
Loading...
Need help?
General