1-4
Examples
# Copy the configurations of Ethernet 1/0/1 to Ethernet 1/0/2 and Ethernet 1/0/3.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] copy configuration source ethernet 1/0/1 destination ethernet 1/0/2 ethernet 1/0/3
Note: The following will be removed from destination port list:
Aggregation port(s), Voice vlan port(s).
Copying VLAN configuration...
Copying Protocol based VLAN configuration...
Copying LACP configuration...
Copying QOS configuration...
Copying GARP configuration...
Copying STP configuration...
Copying speed/duplex configuration...
z Any aggregation group port you input in the destination port list will be removed from the list and the
copy command will not take effect on the port. If you want an aggregation group port to have the
same configuration with the source port, you can specify the aggregation group of the port as the
destination (with the destination-agg-id argument).
z Any voice-VLAN-enabled port you input in the destination port list will be removed from the list.
# Copy the configurations of GigabitEthernet 1/1/1 to Ethernet 1/0/1.
[Sysname]copy configuration source g1/1/1 destination e1/0/1
Copying VLAN configuration...
Copying Protocol based VLAN configuration...
Copying LACP configuration...
Copying QOS configuration...
Copying GARP configuration...
Copying STP configuration...
Copying speed/duplex configuration...
Copying speed configuration to interface Ethernet1/0/1 failed
Copying QoS rate limit configuration to interface Ethernet1/0/2 failed
The output shows that all configurations except port rate limiting and QoS traffic policing were copied
successfully.
description
Syntax
description text
undo description
To Next Page
Loading...
Need help?
General