3-11
Related commands: multicast routing-enable.
Examples
# Enable PIM-DM on VLAN-interface 10.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] multicast routing-enable
[Sysname] interface Vlan-interface 10
[Sysname-Vlan-interface10] pim dm
pim neighbor-limit
Syntax
pim neighbor-limit limit
undo pim neighbor-limit
View
Interface view
Parameters
limit: Maximum number of PIM neighbors on the interface, in the range of 0 to 128.
Description
Use the pim neighbor-limit command to configure the upper threshold of the number of PIM neighbors
on the current interface. The switch will add no more neighbors for the interface when the limit is
reached.
Use the undo pim neighbor-limit command to restore the default.
By default, a switch can have a maximum of 128 PIM neighbors on an interface.
If you figure a threshold smaller than the current number of PIM neighbors, the existing PIM neighbors
will not be deleted immediately.
Examples
# Limit the number of PIM neighbors to 50 on VLAN-interface 10.
<Sysname>system-view
System View: return to User View with Ctrl+Z.
[Sysname] multicast routing-enable
[Sysname] interface Vlan-interface 10
[Sysname-Vlan-interface10] pim neighbor-limit 50
pim neighbor-policy
Syntax
pim neighbor-policy acl-number
undo pim neighbor-policy
To Next Page
Loading...
Need help?
General