1-14
On a trunk port, only traffic of the default VLAN can pass through untagged.
You can perform the command multiple times. The VLANs specified each time does not overwrite those
configured before, if any.
Related commands: port link-type.
Examples
# Assign the trunk port Ethernet 1/0/1 to VLAN 2, VLAN 4, and VLAN 50 through VLAN 100.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] port link-type trunk
[Sysname-Ethernet1/0/1] port trunk permit vlan 2 4 50 to 100
Please wait... Done.
port trunk pvid vlan
Syntax
port trunk pvid vlan vlan-id
undo port trunk pvid
View
Ethernet port view
Parameters
vlan-id: Specifies the default VLAN ID of the current port, in the range of 1 to 4094.
Description
Use the port trunk pvid vlan command to set the default VLAN ID for the trunk port. A trunk port sends
packets of the default VLAN untagged.
Use the undo port trunk pvid command to restore the default.
By default, the default VLAN ID of a trunk port is VLAN 1.
After configuring the default VLAN of a trunk port, you need to use the port trunk permit vlan
command to configure the trunk port to allow the packets of the default VLAN to pass through.
If the specified default VLAN has been removed or is not carried on the trunk port, the port will be unable
to receive VLAN untagged packets.
The local and remote trunk ports must use the same default VLAN ID for the traffic of the default VLAN
to be transmitted properly.
Related commands: port link-type, port trunk permit vlan.
To Next Page
Loading...
Need help?
General