4-11
Parameters
peer-address: Specifies an MSDP peer by its IP address.
interface-type interface-number: Specifies an interface by its type and number. The switch will use the
primary address of this interface as the source IP to establish a TCP connection with the remote MSDP
peer.
Description
Use the peer connect-interface command to specify an MSDP peer and connect the switch with the
MSDP peer through the specified interface.
Use the undo peer connect-interface command to remove an MSDP peering connection.
If an MSDP peer of the switch is a BGP peer to this switch at the same time, the same IP address must
be used for both the MSDP peering connection and the BGP peering connection.
Related commands: static-rpf-peer.
Examples
# Configure the switch whose IP address is 125.10 .7.6 as the MSDP peer of the switch and establish a
peering connection with the MSDP peer through VLAN-interface 100.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] msdp
[Sysname-msdp] peer 125.10.7.6 connect-interface Vlan-interface 100
peer description
Syntax
peer peer-address description text
undo peer peer-address description
View
MSDP view
Parameters
peer-address: Specifies an MSDP peer by its IP address.
text: Descriptive text, case-sensitive. The maximum length is 80 characters.
Description
Use the peer description command to configure the descriptive text for an MSDP peer so that the
administrator can easily distinguish MSDP peers.
Use the undo peer description command to remove the configured descriptive text.
By default, no descriptive text is configured for any MSDP peer.
Related commands: display msdp peer-status.
Examples
# Add the description text Router CstmrA for the MSDP peer 125.10.7.6, meaning that peer is
customer A.
To Next Page
Loading...
Need help?
General