H3C S3600 Series

4-13
Use the undo peerminimum-ttl command to restore the system default.
By default, the minimum required TTL value is 0.
Related commands: peer.
Examples
# Set the minimum required TTL value of encapsulated multicast packet to 10 so that only those
multicast data packets with a TTL value greater than or equal to 10 can be forwarded to the MSDP peer
110.10.10.1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] msdp
[Sysname-msdp] peer 110.10.10.1 minimum-ttl 10
peer request-sa-enable
Syntax
peer peer-address request-sa-enable
undo peer peer-address request-sa-enable
View
MSDP view
Parameters
peer-address: Specifies an MSDP peer by its IP address.
Description
Use the peer request-sa-enable command to enable the switch to send an SA request message to the
specified MSDP peer upon receipt of a Join message.
Use the undo peer request-sa-enable command to remove the configuration.
By default, upon receipt of a Join message, the switch sends no SA request message to the MSDP peer
but waits for the next SA message.
Related commands: cache-sa-enable.
Examples
# Configure to send an SA request message to the MSDP peer 125.10.7.6.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] msdp
[Sysname-msdp] peer 125.10.7.6 request-sa-enable
peer sa-cache-maximum
Syntax
peer peer-address sa-cache-maximum sa-limit
undo peer peer-address sa-cache-maximum