5-2
apply tag
Syntax
apply tag value
undo apply tag
View
Route policy view
Parameters
value: Tag value of a route, in the range of 0 to 4294967295.
Description
Use the apply tag command to configure a tag for a route.
Use the undo apply tag command to remove the configuration.
By default, no tag is configured for a route.
Related commands: if-match interface, if-match acl, if-match ip-prefix, if-match ip next-hop,
if-match cost, if-match tag, route-policy, apply cost.
Examples
# Create a routing policy named policy and node 1 with the matching mode being permit. Apply the tag
100 to routes matching ACL 2000.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] route-policy policy permit node 1
%New sequence of this list
[Sysname-route-policy] if-match acl 2000
[Sysname-route-policy] apply tag 100
display ip ip-prefix
Syntax
display ip ip-prefix [ ip-prefix-name ]
View
Any view
Parameters
ip-prefix-name: Name of an IP-prefix, a string of up to 19 characters.
Description
Use the display ip ip-prefix command to display information about an IP-prefix(es).
When ip-prefix-name is not specified, information about all the configured IP-prefixes is displayed.
Related commands: ip ip-prefix.
To Next Page
Loading...
Need help?
General