3-3
display cpu
Syntax
display cpu [ unit unit-id ]
View
Any view
Parameters
unit-id: Unit ID of a switch.
Description
Use the display cpu command to display the CPU usage.
Examples
# Display the CPU usage of this switch.
<Sysname> display cpu
Unit 1
Board 0 CPU busy status:
12% in last 5 seconds
12% in last 1 minute
12% in last 5 minutes
Table 3-2 Description on the fields of the display cpu command
Field Description
CPU busy status CPU usage status.
12% in last 5 seconds
12% in last 1 minute
12% in last 5 minutes
The CPU usage in the last five seconds is 12%.
The CPU usage in the last one minute is 12%.
The CPU usage in the last five minutes is 12%.
display device
Syntax
display device [ manuinfo [ unit unit-id ] | unit unit-id ]
View
Any view
Parameters
manuinfo: Specifies to display the manufacture information of the specified switch.
unit-id: Unit ID of a switch.
Description
Use the display device command to display the information, such as the module type and operating
status, about each board (main board and sub-board) of a specified switch.
To Next Page
Loading...
Need help?
General