3-5
Unit 1
Fan 1 State: Normal
The above information indicates that the fan works normally.
display memory
Syntax
display memory [ unit unit-id | limit ]
View
Any view
Parameters
unit-id: Unit ID of a switch.
limit: Specifies to display the memory configuration information of the switch.
Description
Use the display memory command to display the memory usage of a specified switch.
Currently, the limit keyword is available on S3600-EI series Ethernet switches only.
Examples
# Display the memory usage of this switch.
<Sysname> display memory
Unit 1
System Available Memory(bytes): 30045312
System Used Memory(bytes): 15698468
Used Rate: 52%
Table 3-4 Description on the fields of the display memory command
Field Description
System Available Memory(bytes) Available memory size of the system, in bytes
System Used Memory(bytes) Used memory size of the system, in bytes
Used Rate Percentage of the used memory
# Display the current memory configuration information of this switch.
<Sysname> display memory limit
Current memory limit configuration information:
system memory safety: 5 (MBytes)
system memory limit: 4 (MBytes)
auto-establish enabled
Free Memory: 17067424 (Bytes)
The state information about connection:
The times of disconnect: 0
To Next Page
Loading...
Need help?
General