1-36
Description
Use the key command to set a shared key for RADIUS authentication/authorization messages or
accounting messages.
Use the undo key command to restore the corresponding default shared key setting.
By default, no shared key exists.
Note that:
z Both RADIUS client and server adopt MD5 algorithm to encrypt RADIUS messages before
exchanging the messages with each other.
z The two parties verify the validity of the RADIUS messages received from each other by using the
shared keys that have been set on them, and can accept and respond to the messages only when
both parties have same shared key.
z The authentication/authorization shared key and the accounting shared key you set on the switch
must be respectively consistent with the shared key on the authentication/authorization server and
the shared key on the accounting server.
Related commands: primary accounting, primary authentication, radius scheme.
Examples
# Set "hello" as the shared key for RADIUS authentication/authorization messages in RADIUS scheme
radius1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] radius scheme radius1
New Radius scheme
[Sysname-radius-radius1] key authentication hello
# Set "ok" as the shared key for RADIUS accounting messages in RADIUS scheme radius1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] radius scheme radius1
New Radius scheme
[Sysname-radius-radius1] key accounting ok
local-server
Syntax
local-server enable
undo local-server
View
System view
Parameters
None
Description
Use the local-server enable command to enable the UDP ports for local RADIUS services.
To Next Page
Loading...
Need help?
General