4-8
Related commands: router id.
Examples
# Display the router ID.
<Sysname> display router id
Configured router id is 1.1.1.1
display ospf abr-asbr
Syntax
display ospf [ process-id ] abr-asbr
View
Any view
Parameters
process-id: OSPF process ID, in the range of 1 to 65535. If you do not specify a process ID, this
command applies to all current OSPF processes.
Description
Use the display ospf abr-asbr command to display the information about the ABR and ASBR of OSPF.
If you use this command on routers in a stub area, no ASBR information is displayed.
Examples
# Display the information about the OSPF ABRs and ASBRs.
<Sysname> display ospf abr-asbr
OSPF Process 1 with Router ID 1.1.1.1
Routing Table to ABR and ASBR
I = Intra i = Inter A = ASBR B = ABR S = SumASBR
Destination Area Cost Nexthop Interface
IA 2.2.2.2 0.0.0.0 10 10.153.17.89 Vlan-interface1
Table 4-1 Description on the fields of the display ospf abr-asbr command
Field Description
I = Intra i = Inter
A = ASBR B = ABR S = SumASBR
Type of the route to the ABR or ASBR:
Intra: intra-area route
Inter: Inter-area route
ASBR: Route to the ASBR
ABR: Route to the ABR
SumASBR: Summary route to the ASBR
Destination Router ID of the ABR or ASBR
Area Area where the router is connected to the ABR or ASBR
Cost Cost of the route from the local router to the ABR or ASBR
To Next Page
Loading...
Need help?
General