1-28
By default, the HWPing server function is disabled.
Related commands: hwping-agent enable, hwping-server tcpconnect, hwping-server udpecho.
Examples
# Enable a HWPing server.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping-server enable
hwping-server tcpconnect
Syntax
hwping-server tcpconnect ip-address port-number
undo hwping-server tcpconnect ip-address port-number
View
System view
Parameters
ip-address: IP address specified for a TCP listening service on the HWPing server.
port-number: Port number specified for a TCP listening service on the HWPing server. The value
ranges from 1 to 65535. It is not recommended to use the ports with a number greater than 50000 or
some special ports (that is, those used for fixed functions, such as port 1701). Otherwise, the HWPing
test may fail.
Description
Use the hwping-server tcpconnect command to create a TCP listening service on the HWPing server.
Use the undo hwping-server tcpconnect command to remove the created TCP listening service.
When performing a TCP connection test on a specified port of a HWPing client, you must create a TCP
listening on the HWPing server if the server is an H3C S3600 series Ethernet switch; otherwise, the
TCP test may fail.
Related commands: hwping-server enable.
Examples
# Enable TCP listening, using 169.254.10.2 as the IP address and 9000 as the port number.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping-server tcpconnect 169.254.10.2 9000
hwping-server udpecho
Syntax
hwping-server udpecho ip-address port-number
undo hwping-server udpecho ip-address port-number
To Next Page
Loading...
Need help?
General