5-19
Description
Use the multicast static-group vlan command to configure the current port in the specified VLAN as a
static member port for the specified multicast group.
Use the undo multicast static-group vlan command to remove the current port in the specified VLAN
as a static member port for the specified multicast group.
By default, no port is configured as a static multicast group member port.
The port configured with this command handles Layer 2 multicast traffic only, rather than Layer 3
multicast traffic.
Examples
# Configure port Ethernet1/0/1 in VLAN 2 as a static member port for multicast group 225.0.0.1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname]interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] multicast static-group 225.0.0.1 vlan 2
multicast static-router-port
Syntax
multicast static-router-port interface-type interface-number
undo multicast static-router-port interface-type interface-number
View
VLAN view
Parameters
interface-type interface-number: Specifies a port by its type and number.
Description
Use the multicast static-router-port command to configure the specified port in the current VLAN as a
static router port.
Use the undo multicast static-router-port command to remove the specified port in the current VLAN
as a static router port.
By default, a port is not a static router port.
Examples
# Configure Ethernet 1/0/1 in VLAN 10 as a static router port.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
To Next Page
Loading...
Need help?
General