H3C S3600 Series

4-32
log-peer-change
Syntax
log-peer-change
undo log-peer-change
View
OSPF view
Parameters
None
Description
Use the log-peer-change command to enable logging of OSPF neighbor state changes.
Use the undo log-peer-change command to disable logging of OSPF neighbor state changes.
By default, logging of OSPF neighbor state changes is disabled.
Note that:
With the logging enabled, the system will output log information when a neighbor changes to the Full
state or to the Down state.
Neighbor states include Down, Init, Attempt, 2-Way, Exstart, Exchange, Loading and Full.
Examples
# Enable logging of neighbor state changes.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] ospf 1
[Sysname-ospf-1] log-peer-change
multi-path-number
Syntax
multi-path-number value
undo multi-path-number
View
OSPF view
Parameters
value: Number of equal cost multi-path (ECMP) routes, in the range of 1 to 3.
Description
Use the multi-path-number command to set the number of OSPF ECMP routes.
Use the undo multi-path-number command to restore the default.
By default, the number of OSPF ECMP routes is 3.