H3C S3600 Series

1-3
Description
Use the display detect-group command to display the configuration of the specified detected group or
all detected groups.
Examples
# Display the configuration of detected group 1.
<Sysname> display detect-group 1
detect-group 1 :
detect loop time(s) : 15
ping wait time(s) : 2
detect retry times : 2
detect ip option : and
group state : not detecting
register module num : 0
detect ip count : 1
detect-list ip address next hop
1 202.13.1.55 1.2.3.4
Table 1-1 Description on the fields of the display detect-group command
Field Description
detect-group 1 Detected group number 1
detect loop time(s) Detecting interval, in seconds.
ping wait time(s) Timeout time of a ping operation, in seconds.
detect retry times Number of retries of an auto detect operation.
detect ip option
The logic relationship between the detected objects in the
detected group. It can be and or or.
group state Current state of the detected group
register module num
Number of registered modules (that is, the number of the modules
utilizing the detected group.)
detect ip count Number of the IP addresses contained in a detected group
detect-list Sequence number of an IP address contained in a detected group
ip address IP address to be detected
next hop Next hop IP address
ip route-static detect-group
Syntax
ip route-static ip-address { mask | mask-length } { interface-type interface-number | next-hop }
[ preference preference-value ] [ reject | blackhole ] detect-group group-number
undo ip route-static ip-address { mask | mask-length } [ interface-type interface-number | next-hop ]
[ preference preference-value ]