1-10
Interface : InLoopBack0 State : Active
Table 1-8 Description on the fields of the display ipv6 route-table verbose command
Field Description
Destinations Number of reachable destination networks/hosts
Routes Number of routing entries
Destination Destination network/host IPv6 address.
PrefixLength Prefix length of the destination IPv6 address
NextHop Next hop address
Protocol Routing protocol discovering the route
Interface Egress interface
State
Routing entry state: Active (valid route) or Inactive (invalid
route).
display ipv6 socket
Syntax
display ipv6 socket [ socktype socket-type ] [ task-id socket-id ]
View
Any view
Parameters
socket-type: Type of a socket, in the range of 1 to 3. The value “1” represents a TCP socket, “2” a UDP
socket, and “3” a raw IP socket.
task-id: ID of a task, in the range of 1 to 100.
socket-id: ID of a socket, in the range of 0 to 3072.
Description
Use the display ipv6 socket command to display information related to a specified socket.
With no argument specified, this command displays the information about all the sockets; with only the
socket type specified, the command displays the information about sockets of the specified type; with
the socket type, task ID and socket ID specified, the command displays the information about the
specified socket.
Examples
# Display information related to a specified socket.
<Sysname> display ipv6 socket
SOCK_STREAM:
Task = VTYD(43), socketid = 1, Proto = 6,
LA = ::->23, FA = ::->0,
sndbuf = 8192, rcvbuf = 8192, sb_cc = 0, rb_cc = 0,
socket option = SO_ACCEPTCONN SO_REUSEADDR SO_KEEPALIVE SO_REUSEPORT SO_SETKEEPALIVE,
To Next Page
Loading...
Need help?
General