1-10
View
Ethernet port view
Parameters
None
Description
Use the monitor-port command to configure the destination port in Ethernet port view.
Use the undo monitor-port command to remove the configuration of the destination port in Ethernet
port view.
Note that:
z You cannot configure a member port of an aggregation group, a fabric port, a member port of an
aggregation group, or a port enabled with LACP and STP as the mirroring destination port.
z It is recommended that you use a destination port for port mirroring purpose only. Do not use a
destination port to transmit other service packets.
Related commands: display mirroring-group, display mirror.
z When you configure mirroring destination port on an Ethernet port of an S3600-EI series Ethernet
switch, if mirroring group 1 does not exist, the switch will automatically create local mirroring group
1 and add the destination port to the group; if mirroring group 1 already exists, but is not a local
mirroring group, your configuration of the destination port will fail.
z When you configure mirroring destination port on an Ethernet port of an S3600-SI series Ethernet
switch, if you execute the monitor-port command on different ports, the last configuration takes
effect.
Examples
# Configure Ethernet 1/0/4 as a destination port in Ethernet port view.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet 1/0/4
[Sysname-Ethernet1/0/4] monitor-port
remote-probe vlan enable
Syntax
remote-probe vlan enable
undo remote-probe vlan enable
View
VLAN view
To Next Page
Loading...
Need help?
General