1-4
z The destination-port command has effect on jitter, TCP-Private, and UDP-Private tests only.
z It is not recommended to perform a TCP, UDP, or jitter test on a well-known port (ports with a
number ranging from 1 to 1023) or on a port with a port number greater than 50000. Otherwise, the
HWPing test will fail or the corresponding service of the well-known port will become unavailable.
Examples
# Set the destination port number for a tcpprivate test to 9000.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping administrator tcp
[Sysname-hwping-administrator-tcp] test-type tcpprivate
[Sysname-hwping-administrator-tcp] destination-port 9000
display hwping
Syntax
display hwping { results | history } [ administrator-name operation-tag ]
View
Any view
Parameters
results: Displays results of the last test.
history: Displays the history records of tests.
administrator-name: Name of the administrator who created the HWPing test operation, a string of 1 to
32 characters.
operation-tag: Operation tag, a string of 1 to 32 characters.
Description
Use the display hwping command to display the result of the last HWPing test or the history of
HWPing tests.
Without administrator-name test-operation-tag specified, the command displays the results of all test
groups; without administrator-name test-operation-tag specified, the command displays the results of
the specified test group.
Related commands: test-enable.
Examples
# Display the test results of the test group with administrator name administrator, and operation tag
icmp.
[Sysname-hwping-administrator-icmp] display hwping results administrator icmp
HWPing entry(admin administrator, tag icmp) test result:
To Next Page
Loading...
Need help?
General