2-2
Examples
# In system view, bind the MAC address 000f-e200-5101 and IP address 10.153.1.1 (supposing they
are MAC and IP addresses of a legal user) to Ethernet 1/0/1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] am user-bind mac-addr 000f-e200-5101 ip-addr 10.153.1.1 interface Ethernet1/0/1
# In Ethernet pot view, bind the MAC address 000f-e200-5102 and IP address 10.153.1.2 (supposing
they are MAC and IP addresses of a legal user) to Ethernet 1/0/2.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet1/0/2
[Sysname-Ethernet1/0/2] am user-bind mac-addr 000f-e200-5102 ip-addr 10.153.1.2
display am user-bind
Syntax
display am user-bind [ interface interface-type interface-number | ip-addr ip-address | mac-addr
mac-address ]
View
Any view
Parameters
interface interface-type interface-number: Specify the port to be bound. The interface-type
interface-number arguments indicate the port type and port number.
ip-addr ip-address: Specify the IP address to be bound.
mac-addr mac-address: Specify the MAC address to be bound. The mac-address argument is in the
form of H-H-H.
Description
Use the display am user-bind command to display port binding information.
If no keyword is specified, this command displays all port bindings.
Related commands: am user-bind.
Examples
# Display all port bindings.
<Sysname> display am user-bind
Following User address bind have been configured:
Mac IP Port
000f-e200-5101 10.153.1.1 Ethernet1/0/1
000f-e200-5102 10.153.1.2 Ethernet1/0/2
Unit 1:Total 2 found, 2 listed.
Total: 2 found.
The above output displays that two port binding settings exist on unit 1:
To Next Page
Loading...
Need help?
General