1-16
100 4 llc dsap 0xac ssap 0xbd
Table 1-3 Description on the fields of the display vlan command
Field Description
Interface Interface bound with at least one protocol VLAN
VLAN ID ID of a protocol VLAN bound with the interface
Protocol-Index Protocol template index
Protocol-type
Protocol type specified by the protocol template.
Refer to the protocol-vlan command for
detailed description.
display protocol-vlan vlan
Syntax
display protocol-vlan vlan { vlan-id1 [ to vlan-id2 ] | all }
View
Any view
Parameters
vlan-id1: Specifies a VLAN ID in the range of 1 to 4094, of which the protocol VLAN configuration
information is to be displayed.
to vlan-id2: In conjunction with vlan-id1, define a VLAN range to display the protocol template
configurations of all protocol VLANs in the range. The vlan-id2 argument takes a value in the range of 1
to 4094, and must not be less than that of vlan-id1.
all: Displays all protocol VLANs and their protocol template information.
Description
Use the display protocol-vlan vlan command to display information about protocol VLANs.
Related commands: protocol-vlan.
Examples
# Display the protocol information and protocol indexes configured for VLAN 10 through VLAN 20.
<Sysname> display protocol-vlan vlan 10 to 20
VLAN ID: 10
VLAN Type: Protocol-based VLAN
Protocol-Index Protocol-Type
0 ip
1 ip
2 ipx ethernetii
3 at
VLAN ID: 15
VLAN Type: Protocol-based VLAN
Protocol-Index Protocol-Type
0 ip
To Next Page
Loading...
Need help?
General