3-6
View
Any view
Parameters
interface interface-type interface-number: Specifies an interface by its type and number.
Description
Use the display pim neighbor command to display the PIM neighbor information.
With an interface specified, the command displays the PIM neighbor information on the specified
interface; otherwise, the command displays the PIM neighbor information on all interfaces.
Examples
# Display the PIM neighbor information on all interfaces.
<Sysname> display pim neighbor
Neighbor Address Interface Name Uptime Expires
8.8.8.6 VLAN-interface10 1637 89
8.8.7.6 VLAN-interface11 1636 88
Table 3-3 display pim neighbor command output description
Field Description
Neighbor Address Neighbor address
Interface Name VLAN interface on which the neighbor has been discovered
Uptime Time elapsed since the multicast group was discovered
Expires Remaining lifetime of the PIM neighbor
display pim routing-table
Syntax
display pim routing-table [ { { *g [ group-address [ mask { mask-length | mask } ] ] | **rp [ rp-address
[ mask { mask-length | mask } ] ] } | { group-address [ mask { mask-length | mask } ] | source-address
[ mask { mask-length | mask } ] } * } | incoming-interface interface-type interface-number |
{ dense-mode | sparse-mode } ] *
View
Any view
Parameters
*g: Specifies a (*, G) entry.
**rp: Specifies a (*, *, RP) route entry.
rp-address: RP address.
group-address: Multicast group address, in the range of 224.0.0.0 to 239.255.255.255.
source-address: Multicast source address.
To Next Page
Loading...
Need help?
General