H3C S3600 Series

1-11
display queue-scheduler
Syntax
display queue-scheduler
View
Any view
Parameters
None
Description
Use the display queue-scheduler command to display the global queue scheduling configuration.
This command does not display the weight or bandwidth set for a queue in port view. To display the
setting, you can perform the display this command in port view.
Related commands: queue-scheduler.
Examples
# Display the global queue scheduling configuration.
<Sysname> display queue-scheduler
Queue scheduling mode: weighted round robin
weight of queue 0: 1
weight of queue 1: 2
weight of queue 2: 3
weight of queue 3: 4
weight of queue 4: 5
weight of queue 5: 9
weight of queue 6: 13
weight of queue 7: 15
Refer to Table 1-3 for the description of the output fields.
line-rate
Syntax
line-rate { inbound | outbound } target-rate [ burst-bucket burst-bucket-size ]
undo line-rate{ inbound | outbound }
View
Ethernet port view
Parameters
inbound: Limits the inbound packet rate.
outbound: Limits the outbound packet rate.
target-rate: Total target rate (in kbps). The range of this argument varies with port type as follows:
z Fast Ethernet port: 64 to 99,968;