3-2
default cost
Syntax
default cost value
undo default cost
View
RIP view
Parameters
value: Default cost, in the range of 1 to 16.
Description
Use the default cost command to set the default cost for redistributed routes.
Use the undo default cost command to restore the default.
By default, the default cost of a redistributed route is 1.
If no cost is specified when you use the import-route command to redistribute routes from another
routing protocol, the routes will be redistributed with the default cost specified with the default cost
command.
Related commands: import-route.
Examples
# Redistribute static routes and set the default cost of the redistributed routes to 3.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] rip
[Sysname-rip] import-route static
[Sysname-rip] default cost 3
display rip
Syntax
display rip
View
Any view
Parameters
None
Description
Use the display rip command to display the current RIP operation state and RIP configuration.
Examples
# Display the current RIP operation state and configuration.
<Sysname> display rip
To Next Page
Loading...
Need help?
General