1-29
View
Ethernet port view
Parameters
10: Specifies the port speed to 10 Mbps.
100: Specifies the port speed to 100 Mbps.
1000: Specifies the port speed to 1,000 Mbps (only available to GigabitEthernet ports).
auto: Specifies the port speed to the auto-negotiation mode.
Description
Use the speed command to set the port speed.
Use the undo speed command to restore the port speed to the default setting.
By default, the port speed is in the auto-negotiation mode.
Note that you can only specify the 1000 and auto keyword for Gigabit Ethernet ports.
Related commands: duplex.
Examples
# Set the speed of Ethernet 1/0/1 to 10 Mbps.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] speed 10
speed auto
Syntax
speed auto [ 10 | 100 | 1000 ]*
View
Ethernet port view
Parameters
10: Configures 10 Mbps as an auto-negotiation speed of the port.
100: Configures 100 Mbps as an auto-negotiation speed of the port.
1000: Configures 1,000 Mbps as an auto-negotiation speed of the port.
Description
Use the speed auto [ 10 | 100 | 1000 ]* command to configure auto-negotiation speed(s) for the current
port.
By default, the port speed is auto-negotiated.
The last configuration will take effect if you configure the command for multiple times.
Examples
# Configure 10 Mbps and 1000 Mbps as the auto-negotiation speeds of Ethernet 1/0/1.
To Next Page
Loading...
Need help?
General