1-36
<123_1.Sysname> tftp cluster put config.cfg temp.cfg
tftp-server
Syntax
tftp-server ip-address
undo tftp-server
View
Cluster view
Parameters
ip-address: IP address of a TFTP server to be configured for the cluster.
Description
Use the tftp-server command to configure a shared TFTP server for the cluster on the management
device.
Use the undo tftp-server command to remove the shared TFTP server setting.
By default, no shared TFTP server is configured.
After the IP address of the shared TFTP server is configured, NAT is enabled on the management
device immediately. When a member device uses the tftp cluster get or tftp cluster put command to
download or upload a file from the shared TFTP server, the management device translates the private
IP address of the member device to a public network address, forwards the requests of the member
device to the TFTP server, and forwards the responses of TFTP server to the member device according
to the NAT record.
Note that you can only use the commands on a management device.
Examples
# Configure shared TFTP server 1.0.0.9 on the management device for the cluster.
<aaa_0.Sysname> system-view
System View: return to User View with Ctrl+Z.
[aaa_0.Sysname] cluster
[aaa_0.Sysname-cluster] tftp-server 1.0.0.9
timer
Syntax
timer interval
undo timer
View
Cluster view
Parameters
interval: Interval (in seconds) to send handshake packets. This argument ranges from 1 to 255.
To Next Page
Loading...
Need help?
General