1-4
Table 1-3 Description on the fields of the display ipv6 host command
Field Description
Host Host name
Age
Time for the entry to live, displayed as 0 in the case of static
configuration.
Flags
Flag indicating whether the entry is configured statically or
acquired dynamically
IPv6Address (es) IPv6 address corresponding to a host name
display ipv6 interface
Syntax
display ipv6 interface [ interface-type interface-number | brief ]
View
Any view
Parameters
interface-type: Interface type.
interface-number: Interface number.
brief: Displays the brief IPv6 information of an interface.
Description
Use the display ipv6 interface command to display the IPv6 information of a specified interface.
If no interface is specified, the IPv6 information of all interfaces for which IPv6 addresses can be
configured is displayed; if only interface-type is specified, the IPv6 information of the interfaces of the
specified type for which IPv6 addresses can be configured is displayed; if interface-type
interface-number is specified, the IPv6 information of the specified interface is displayed.
If the brief keyword is specified, the brief IPv6 information of the interface is displayed.
Examples
# Display the IPv6 information of a VLAN interface.
<Sysname> display ipv6 interface Vlan-interface 1
Vlan-interface1 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::2E0:FCFF:FE00:C
Global unicast address(es):
2008::5600, subnet is 2008::/64
Joined group address(es):
FF02::1:FF00:5600
FF02::1:FF00:C
FF02::1
MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 5
To Next Page
Loading...
Need help?
General