1-28
Parameters
None
Description
Use the shutdown command to shut down an Ethernet port.
Use the undo shutdown command to bring up an Ethernet port.
By default, an Ethernet port is in up state.
Examples
# Shut down Ethernet 1/0/1 and then bring it up.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] shutdown
#Apr 13 23:13:53:600 2000 Sysname L2INF/2/PORT LINK STATUS CHANGE:- 1 -
Trap 1.3.6.1.6.3.1.1.5.3(linkDown): portIndex is 4227650, ifAdminStatus is 2, ifOperStatus
is 2
%Apr 13 23:13:53:807 2000 Sysname L2INF/5/PORT LINK STATUS CHANGE:- 1 -
Ethernet1/0/4 is DOWN
%Apr 13 23:13:53:927 2000 Sysname L2INF/5/VLANIF LINK STATUS CHANGE:- 1 -
Vlan-interface3 is DOWN
%Apr 13 23:13:54:057 2000 Sysname IFNET/5/UPDOWN:- 1 -Line protocol on the interface
Vlan-interface3 is DOWN
# Enable Ethernet 1/0/1.
[Sysname-Ethernet1/0/1] undo shutdown
#Apr 13 23:14:54:454 2000 Sysname L2INF/2/PORT LINK STATUS CHANGE:- 1 -
Trap 1.3.6.1.6.3.1.1.5.4(linkUp): portIndex is 4227650, ifAdminStatus is 1, ifOperStatus
is 1
%Apr 13 23:14:54:657 2000 Sysname L2INF/5/PORT LINK STATUS CHANGE:- 1 -
Ethernet1/0/4 is UP
%Apr 13 23:14:54:777 2000 Sysname L2INF/5/VLANIF LINK STATUS CHANGE:- 1 -
Vlan-interface3 is UP
%Apr 13 23:14:54:897 2000 Sysname IFNET/5/UPDOWN:- 1 -Line protocol on the interface
Vlan-interface3 is UP
speed
Syntax
speed { 10 | 100 | 1000 | auto }
undo speed
To Next Page
Loading...
Need help?
General