H3C S3600 Series

1-7
Use the undo info-center channel command to restore the default name of the channel whose
number is channel-number.
By default, the name of channel 0 to channel 9 is (in turn) console, monitor, loghost, trapbuffer,
logbuffer, snmpagent, channel6, channel7, channel8, channel9.
Do not configure two different channels with the same name.
Examples
# Name channel 0 as “execconsole”.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] info-center channel 0 name execconsole
info-center console channel
Syntax
info-center console channel { channel-number | channel-name }
undo info-center console channel
View
System view
Parameters
channel-number: Channel number, ranging from 0 to 9, corresponding to the 10 channels of the system.
channel-name: Channel name, by default, the name of channel 0 to channel 9 is (in turn) console,
monitor, loghost, trapbuffer, logbuffer, snmpagent, channel6, channel7, channel8, channel9.
Description
Use the info-center console channel command to set the channel through which information is output
to the console.
Use the undo info-center console channel command to restore the default channel through which
system information is output to the console.
By default, output of information to the console is enabled with channel 0 as the default channel (known
as console).
This command works only when the information center is enabled.
Related commands: info-center enable and display info-center.
Examples
# Configure to output information to the console through channel 0.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] info-center console channel 0