3-2
resilient-arp enable
Syntax
resilient-arp enable
undo resilient-arp enable
View
System view
Parameters
None
Description
Use the resilient-arp enable command to enable the Resilient ARP function. The switch will adopt
different methods based on the actual status. If the main link in the fabric breaks, the switch sends
resilient ARP packets through the VLAN interface on the backup link to determine whether it should act
as a Layer 3 or Layer 2 device.
Use the undo resilient-arp enable command to disable the Resilient ARP function.
By default, the Resilient ARP function is enabled.
Related commands: display resilient-arp.
Examples
# Enable the Resilient ARP function.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] resilient-arp enable
resilient-arp interface vlan-interface
Syntax
resilient-arp interface Vlan-interface vlan-id
undo resilient-arp interface Vlan-interface vlan-id
View
System view
Parameters
vlan-id: VLAN interface ID.
Description
Use the resilient-arp interface Vlan-interface command to enable the VLAN interface to send
Resilient ARP packets.
Use the undo resilient-arp interface Vlan-interface command to disable the VLAN interface from
sending Resilient ARP packets.
By default, Resilient ARP packets are sent through VLAN-interface 1.
To Next Page
Loading...
Need help?
General