4-26
display ospf retrans-queue
Syntax
display ospf [ process-id ] retrans-queue
View
Any view
Parameters
process-id: OSPF process ID, in the range of 1 to 65535. If you do not specify a process ID, this
command applies to all current OSPF processes.
Description
Use the display ospf retrans-queue command to display the information about the OSPF
retransmission queue.
Examples
# Display the information about the OSPF retransmission queue.
<Sysname> display ospf retrans-queue
OSPF Process 200 with Router ID 103.160.1.1
Retransmit List
The Router's Neighbors is
RouterID: 162.162.162.162 Address: 103.169.2.2
Interface: 103.169.2.5 Area: 0.0.0.1
Retrans list:
Type: ASE LSID:129.11.77.0 AdvRouter:103.160.1.1
Type: ASE LSID:129.11.108.0 AdvRouter:103.160.1.1
Table 4-14 Description on the fields of the display ospf retrans-queue command
Field Description
RouterID ID of a neighbor router
Address IP address of the interface on a neighbor router
Interface IP address of the interface on the local router
Retrans list Retransmit list
Area Area number of OSPF
Type Type of the LSA
LSID Link State ID of the LSA
AdvRouter Router ID of the router that advertises the LSA
display ospf routing
Syntax
display ospf [ process-id ] routing
To Next Page
Loading...
Need help?
General