3-17
Before rebooting, the system checks whether there is any configuration change. If yes, it prompts
whether or not to proceed. This prevents the system from losing the configurations in case of shutting
down the system without saving the configurations.
Examples
# Directly restart this switch without saving the current configuration.
<Sysname> reboot
Start to check configuration with next startup configuration file,
please wait......
This command will reboot the device. Current configuration will be lost in next startup if
you continue. Continue? [Y/N] y
This will reboot device. Continue? [Y/N] y
<Sysname>
%Apr 2 00:06:01:148 2006 Sysname DEV/5/DEV_LOG:- 1 -
Switch is rebooting...
Starting......
schedule reboot at
Syntax
schedule reboot at hh:mm [ mm/dd/yyyy | yyyy/mm/dd ]
undo schedule reboot
View
User view
Parameters
hh:mm: Reboot time, where hh (hour) ranges from 0 to 23, and mm (minute) ranges from 0 to 59.
mm/dd/yyyy and yyyy/mm/dd: Two formats used to specify the reboot date, where yyyy (year) ranges
from 2,000 to 2,099, mm (month) ranges from 1 to 12, and the range of dd (day) depends on the specific
month. You cannot set the date 30 days later than the system current date.
Description
Use the schedule reboot at command to enable the scheduled reboot function on the current switch
and set the reboot date and time.
Use the undo schedule reboot command to disable the scheduled reboot function.
By default, no scheduled reboot is set on the switch.
To Next Page
Loading...
Need help?
General